ESP8266 Community Forum

- Wed May 27, 2015 1:31 am #18575 Moin,

I suggest looking at esptool.py code.

Cal

For what its worth:
Nodemcu does some size detection here:

https://github.com/nodemcu/nodemcu-firm ... lash_api.c

Get your modules here:

https://www.banggood.com/custlink/KvGGhGF4wG

- Wed May 27, 2015 5:11 am #18587 Heh, yeah, I was hoping to avoid debugging esptool.py

But if anyone has experienced a similar issue, I'd love to hear for you

Some of my work

- Sun May 31, 2015 2:30 am #19009 Had a similar kind of problem
ESP-01
SDK v1.1.0

compiled AT example and flashed with

Code: Select allesptool.py write_flash 0x00000 eagle.flash.bin 0x40000 eagle.irom0text.bin

device boot success. Serial output garbage. AT commands not working.

flashed with

Code: Select allesptool.py write_flash 0x40000 eagle.irom0text.bin 0x00000 eagle.flash.bin

Serial o/p says ready at baud 115200. AT commands working. A wifi access point is visible but cannot connect to it.

//edit
while this seemed working fine

Code: Select allesptool.py write_flash 0x40000 eagle.irom0text.bin 0x00000 eagle.flash.bin

when in STA mode and connecting to home router ip was not obtained and was getting disconnected after a few seconds.
then tried

Code: Select allesptool.py write_flash 0x00000 eagle.flash.bin 0x40000 eagle.irom0text.bin
esptool.py write_flash 0x00000 eagle.flash.bin

reboot between commands. Now working flawlessly.
And thank you esp03madness. I was struggling before finding this topic

- Tue Jun 02, 2015 12:40 am #19183 glad to help, dev_su

Some of my work