ESP8266 Community Forum

- Mon Dec 01, 2014 9:38 pm #3773

Is AT+CIOBAUD not working in this new firmware?
I can't seem to change it from the default 115200 it set to after flashing.

The new command to change baudrate is AT+IPR, but AT+IPR? and AT+IPR=? are not implemented.

- Mon Dec 01, 2014 9:48 pm #3774 Thank you much garyservin.
Could you tell me where you found that command?

- Mon Dec 01, 2014 10:04 pm #3775 You're welcome! I found it digging through the source code

- Tue Dec 02, 2014 6:49 am #3803 Thanks again garyservin!