ESP8266 Community Forum

- Fri Sep 02, 2016 9:21 am #54318 Hi. I need to change the factory default 115200 baud to 9600 baud using AT+IPR=9600 command.
My question is: is this a non-volatile command; i.e. will the A6 GSM module retain this new 9600 baud on power off or do I have to issue it again at power ON? Thank you.

- Tue Nov 08, 2016 11:56 am #57836 Please find a solution to this?

thanks

- Thu Nov 17, 2016 3:58 am #58243 Same problem here with the A7...
I tried AT&W, but it didn't work. Maybe I did it wrong, its my first module with AT commands :/