ESP-07 and ESP-12 Breadboard Adapters
Posted: Tue Mar 03, 2015 10:19 amI recently had some breadboard adapters made for the ESP-07/12 at OSH Park. 2mm header pins are soldered into the ESP module and then matching 2mm SIP sockets are used to mount the ESP to the adapter (this is the same method used by nearly all XBee radio modules). High quality .020" round machine pin headers are used to mount the adapter to the breadboard (standard .025" square pins tend to ruin the spring terminals inside the breadboard). Uses standard .300" DIP-16 spacing.
I have about a dozen extra adapters if anybody is interested (you'll have to assemble them yourself). I also have two additional ESP8266 development boards being made by OSH Park right now (all of the boards use the same 2mm header mounting solution). I'll post photos when I receive them in about two weeks.
I have about a dozen extra adapters if anybody is interested (you'll have to assemble them yourself). I also have two additional ESP8266 development boards being made by OSH Park right now (all of the boards use the same 2mm header mounting solution). I'll post photos when I receive them in about two weeks.