ESP8266 Community Forum

Sure, I could get another -## version... but I like the -01. Therefore:



[list=]Ripped the plastic of the soldered 2x4 = 8 header off[/list]
[list=]Bent the pins of the outer pin pairs to make the corners of a 4 x 4 grid[/list]
[list=]Bent the pins of the inner pin pairs to take the origin places of the outer pin pairs[/list]

e voila! - you have your breadboard friendly version!

It is certainly the cleanest way I have seen to do it.

That is the smartest thing I have seen in a long-long time .... (bows low to the ground in admiration).