My ESP-04 breakout board (including tout)
Posted: Fri Nov 28, 2014 10:51 amHi.
This is my (not so great) version of a homemade breakout board.
As a plus, I soldered a wire from the TOUT pin at the micro to an NC pin of the module.
The wire in the upper left is the antenna.
The prototype board has 2mm pitch (yes, you can actually buy that), so it fits the module perfectly.
In in case someone asks: the board is from Seeedstudio.
Front:
Back:
Have fun.
This is my (not so great) version of a homemade breakout board.
As a plus, I soldered a wire from the TOUT pin at the micro to an NC pin of the module.
The wire in the upper left is the antenna.
The prototype board has 2mm pitch (yes, you can actually buy that), so it fits the module perfectly.
In in case someone asks: the board is from Seeedstudio.
Front:
Back:
Have fun.