Can't get the GPIO interrupt working - Win Eclipse IDE
Posted: Thu Nov 19, 2015 6:56 amHi all,
I'm using an ESP12, and trying to get an interrupt working on the negative edge of the labelled GPIO4 (which I understand is actually GPIO5!).
I'm using Cherts windows Eclipse IDE, with an old SDK v2.0.5 (22.05.2015). I can't keep up with the updates and having to keep going back to change my code.
Anyway, essentially I just can't get the interrupt called, and its really annoying. I'd appreciate it if anyone could help me out.
This is all I'm doing.
I'm using an ESP12, and trying to get an interrupt working on the negative edge of the labelled GPIO4 (which I understand is actually GPIO5!).
I'm using Cherts windows Eclipse IDE, with an old SDK v2.0.5 (22.05.2015). I can't keep up with the updates and having to keep going back to change my code.
Anyway, essentially I just can't get the interrupt called, and its really annoying. I'd appreciate it if anyone could help me out.
This is all I'm doing.
Code: Select all
void ICACHE_FLASH_ATTR gpioInterrupt (void)
{
DEBUG("In interrupt\r\n");
eth.data_present = 1;
eth.no_reset = 1;
ETS_GPIO_INTR_DISABLE();
}
//#define USE_EASY_GPIO
void ICACHE_FLASH_ATTR ioInit() {}
uint32 gpio_status;
/* Button */
PIN_FUNC_SELECT(PERIPHS_IO_MUX_GPIO0_U, FUNC_GPIO0);
PIN_FUNC_SELECT(PERIPHS_IO_MUX_GPIO5_U, FUNC_GPIO5); // enc reset
PIN_FUNC_SELECT(PERIPHS_IO_MUX_GPIO4_U, FUNC_GPIO4); // enc interrupt
#ifndef USE_EASY_GPIO
/* Clear any interrupt flags related to gpio */
gpio_status = GPIO_REG_READ(GPIO_STATUS_ADDRESS);
GPIO_REG_WRITE(GPIO_STATUS_W1TC_ADDRESS, gpio_status);
gpio_pin_intr_state_set((1<<ENCINTGPIO),GPIO_PIN_INTR_NEGEDGE);
/* Attach and enable the interrupt handler */
ETS_GPIO_INTR_ATTACH(gpioInterrupt , NULL);
ETS_GPIO_INTR_ENABLE();
#else
easygpio_attachInterrupt(ENCINTGPIO, EASYGPIO_NOPULL, gpioInterrupt );
#endif
os_timer_disarm(&resetBtntimer);
os_timer_setfn(&resetBtntimer, resetBtnTimerCb, NULL);
os_timer_arm(&resetBtntimer, 500, 1);
INFO("end io init\r\n");
}