ESP8266 Community Forum

Dear all,
I am very much new in 8266.
My 8266 ESP-07 board arrived yesterday and I am trying to get it working.

I have Arduino IDE version 1.6.6
Boards used: ARDUINO UNO(Atmega328p) and ESP-07

Board interconnections done as follows
ARDUINO ESP-07
--------------- -----------------
Tx -- Tx
Rx -- Rx

ESP-07 connections as follows
Vcc -- +3v
Gnd -- gnd
GPIO 0 -- open
GPIO 2 -- open
GPIO 15 -- GND
EN(CH_PD) -- +3.3v

Serial monitor set to BAUD 115200 NL & CR
BLINK program uploaded on ARDUINO UNO

Now when I power up,

red light on esp-07 lights up.
Now I momentarily connect RST pin of esp-07 to GND I get following in my Serial monitor window

ets Jan 8 2013,rst cause:2, boot mode:(3,7)

load 0x40100000, len 1396, room 16
tail 4
chksum 0x89
load 0x3ffe8000, len 776, room 4
tail 4
chksum 0xe8
load 0x3ffe8308, len 540, room 4
tail 8
chksum 0xc0
csum 0xc0

2nd boot version : 1.4(b1)
SPI Speed : 40MHz
SPI Mode : QIO
SPI Flash Size & Map: 8Mbit(512KB+512KB)
jump to run user1 @ 1000

ŒÿÕ(¤SQS�(RQ¨)HT¨)SHHHC…äÿrŽÃ9ô
Ai-Thinker Technology Co. Ltd.

ready


It does not accept any AT commands....
What am I doing wrong ?

Any help please ?