Eagle ESP12E and ESP12F schematic symbol and footprint
Posted: Tue Feb 23, 2016 8:43 pmSays it all...
Find it here attached.
Find it here attached.
What's your take on the lower horizontal pads (cs0, mosi, gpio9, gpio10, mosi, sclk)? Right now I have them soldered to floating pads, but I have seen them left unsoldered as well (pads are removed). Does it matter at all? Just physical security?
Also looking for someones take on running traces underneath the board. Is it possible to short 'our' traces/vias with the ones on the bottom side of the 12e board? Or should we only worry about the vias shorting each other?
Lastly, if anyone knows their stuff when it comes to RF, does it matter if the 12e's onboard antenna extends out beyond a 'host' board?