Re: No Echo
Posted:
Mon Sep 29, 2014 5:40 am
by al1fch
The proper commands to turn on/off the echo are ATE1 and ATE0, not AT+E1 and AT+E0
ATE1 and ATE0 now works in espressif firmware downloaded by AT+CIUPDATE
volatile comand : Echo ON after AT+RST
(AT+GMR gives 001800092 for this first 'cloud upfated' firmware)
Upgrades tested as shown here : http://blog.electrodragon.com/cloud-updating-your-wi07c-esp8266-now/Browing bin shows downloading from 'iot.espressif.com/v1/rom....."
Re: No Echo
Posted:
Mon Sep 29, 2014 11:12 am
by cnlohr
"Official" firmware seems less and less relevant now as the community project churns along. And, for my purposes, I've been able to write an AVR C library for handling the parsing as it is. But it is good to see that other people recognize the importance of machine-readable protocols.
Re: No Echo
Posted:
Tue Sep 30, 2014 12:32 am
by TCL987
al1fch wrote:The proper commands to turn on/off the echo are ATE1 and ATE0, not AT+E1 and AT+E0
ATE1 and ATE0 now works in espressif firmware downloaded by AT+CIUPDATE
volatile comand : Echo ON after AT+RST
(AT+GMR gives 001800092 for this first 'cloud upfated' firmware)
Upgrades tested as shown here : http://blog.electrodragon.com/cloud-updating-your-wi07c-esp8266-now/
Browing bin shows downloading from 'iot.espressif.com/v1/rom....."
Did you have to change your serial settings after the update? I just get gibberish after updating.
Re: No Echo
Posted:
Tue Sep 30, 2014 12:52 am
by reaper7
For me after update everything works without a problem,
any garbage in the serial.
ATE1 and ATE0 works