ESP8266 Community Forum

- Thu Mar 11, 2021 3:22 pm #90799 Hi, not sure how to reset my module i was told its like a ESp8266 if not can some one tell me what it is or how to reset it?

Basically when setting it up it accepted HEX 10 digit and wpa2-psk as key/auth as as station which wont allow to connect.

Hardware: ELM327 station mode AP DD-wrt, openwrt, n66u Asus, Tried several others Legacy 802.11G
Stations disconnects after a few minutes , tried to reset the WiFi station board - see below)

This site does not allow tm copy and paste the images, they are here formatted properly:
https://github.com/kaloz/mwlwifi/issues/393



OpenWRT AP

image
image

Log from OpenWRT

Wed Mar 10 22:24:23 2021 daemon.info hostapd: wlan1-1: STA 00:25:09XXXXXX IEEE 802.11: deauthenticated due to local deauth request
Wed Mar 10 22:24:31 2021 daemon.info hostapd: wlan1-1: STA 00:25:09XXXXXX IEEE 802.11: associated (aid 1)
Wed Mar 10 22:24:31 2021 daemon.notice hostapd: wlan1-1: AP-STA-POSSIBLE-PSK-MISMATCH 00:25:09XXXXXX
Wed Mar 10 22:24:32 2021 daemon.notice hostapd: wlan1-1: AP-STA-POSSIBLE-PSK-MISMATCH 00:25:09XXXXXX
Picture of Wifi Module, ( did short GND TO RST) to no avail why powering 3.3v, that stuff u see on the RS232 Header came like that from the factory:

image

image

image