ESP8266 Community Forum

Hello. I am just getting into the ESP platform, so everything about it is new to me. I have established an AT connection with the ESP Launcher kit user the SecureCRT emulator under Windows, following the quick start guide for that kit. I have two other terminal emulators, either of which I would prefer to use due to their open license: Putty or TeraTerm. However, I have not been able to make either of those emulators work after trying various settings. Putty comes closest to working so far, but I get no response from the ESP chip upon executing an AT command (I see the blue light responding to my key presses, though.) If someone on the forum is using either of these programs, I would appreciate your sharing your settings with me. Thanks

What are your settings? I was able to use Putty without much hassle. Just have to set the baud rate correctly. Make sure you're sending a CRLF at the end of the command, too.