Powering up ESP8266 12E
Posted: Sat Feb 11, 2017 12:07 pmHow to power up esp8266 12e? It is fully programmed, I just want to give it power. How to connect?
Here's the picture
Here's the picture
ESP8266 Community Forum
Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/
Powering up ESP8266 12E
Page 1 of 1
Posted: Sat Feb 11, 2017 12:07 pmRe: Powering up ESP8266 12E
Posted: Sat Feb 11, 2017 2:22 pmRe: Powering up ESP8266 12E
Posted: Sat Feb 11, 2017 5:27 pmMost of the schematics on the net are incomplete. (including the ones in the previous poster's link) Most do not show the required pull-up resistor on D2. The following schematic is almost adequate. Eliminate the deep-sleep resistor if you are not using that function.
Add a capacitor across the Vcc and ground. Use a 0.1uF as shown but also a larger cap like a 100uF-470uF. Make these as close to the power pins on the module.
Make sure that any voltages applied to the ESP8266 are no greater than 3.3 volts.
Add a capacitor across the Vcc and ground. Use a 0.1uF as shown but also a larger cap like a 100uF-470uF. Make these as close to the power pins on the module.
Make sure that any voltages applied to the ESP8266 are no greater than 3.3 volts.