Page 1 of 1
ESP8266 SMT Module 12-S Soldering Mistake
Posted:
Wed May 03, 2017 10:55 pmby jumpy
I'm new to the ESP8266 and had bought the SMT Module because I needed its small form factor and weight. I read I needed to pull up GPIO0 to flash a program, but my iron must have been on too hot and I soldered the trace pad off. Is it still possible to flash programs without GPIO0 pulled high? If so, how?
Re: ESP8266 SMT Module 12-S Soldering Mistake
Posted:
Mon May 08, 2017 1:30 pmby jeffas
Not as far as I know, no. Without GPIO0 pulled high, the module will just run whatever sketch is loaded.
Re: ESP8266 SMT Module 12-S Soldering Mistake
Posted:
Mon May 08, 2017 1:42 pmby rudy
GPIO0 needs to be low in order to program the device. To run the code it needs to be high. If you are not able to control that line then you will not be able to use it.
Re: ESP8266 SMT Module 12-S Soldering Mistake
Posted:
Mon May 08, 2017 3:52 pmby jeffas
˙uʍop ǝpᴉsdn ʇɐɥʇ ʇoƃ I ʎɹɹoS ˙ʎpnɹ sʞuɐɥ┴