Can not communicate using ESPlorer
Posted: Sat May 20, 2017 5:24 pmHi, I am trying to send my first program to NodeMCU ESP8266 using ESPlorer. Here is what I received after clicking Open:
"PORT OPEN 115200
Communication with MCU..Got answer! Communication with MCU established.
AutoDetect firmware...
Can't autodetect firmware, because proper answer not received (may be unknown firmware).
Please, reset module or continue. " + a bunch of strange characters.
And when I tried to send simple program:
"Waiting answer from ESP - Timeout reached. Command aborted."
Baud rate: 115200
Serial port chooser: COM6 (I think it is not a mistake)
I have used this: https://github.com/nodemcu/nodemcu-flasher
to flash. When I use Arduino IDE to send simply program (Blink), it works. Here are some photos of my NodeMCU: https://nettigo.pl/products/modul-wifi- ... sp8266-12e
I have tried to read documentation and search soultion on the Internet but I am only getting confused. Have you got any ideas how could I communicate with NodeMCU using ESPlorer?
Kind regards
Czarek
"PORT OPEN 115200
Communication with MCU..Got answer! Communication with MCU established.
AutoDetect firmware...
Can't autodetect firmware, because proper answer not received (may be unknown firmware).
Please, reset module or continue. " + a bunch of strange characters.
And when I tried to send simple program:
"Waiting answer from ESP - Timeout reached. Command aborted."
Baud rate: 115200
Serial port chooser: COM6 (I think it is not a mistake)
I have used this: https://github.com/nodemcu/nodemcu-flasher
to flash. When I use Arduino IDE to send simply program (Blink), it works. Here are some photos of my NodeMCU: https://nettigo.pl/products/modul-wifi- ... sp8266-12e
I have tried to read documentation and search soultion on the Internet but I am only getting confused. Have you got any ideas how could I communicate with NodeMCU using ESPlorer?
Kind regards
Czarek