AT+RST MEM CHECK FAIL!!! - correct operation?
Posted: Tue Oct 03, 2017 7:59 amEvery time I try to restart my esp-01 with the command AT+RST I get the following response:
AT+RST
OK
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
load 0x40100000, len 1396, room 16
tail 4
chksum 0x89
load 0x3ffe8000, len 776, room 4
tail 4
chksum 0xe8
load 0x3ffe8308, len 540, room 4
tail 8
chksum 0xc0
csum 0xc0
2nd boot version : 1.4(b1)
SPI Speed : 40MHz
SPI Mode : QIO
SPI Flash Size & Map: 8Mbit(512KB+512KB)
jump to run user1 @ 1000
ŒÂÕ�MEM CHECK FAIL!!!
d{$�‚sú
Ai-Thinker Technology Co. Ltd.
invalid
What could be the reason for this statement?
Is it a regular operation statement without any further meaning for me?
I'm using the Arduino IDE with a baud rate of 115200 together with the board settings Generic ES8266 Module
AT+RST
OK
ets Jan 8 2013,rst cause:2, boot mode:(3,6)
load 0x40100000, len 1396, room 16
tail 4
chksum 0x89
load 0x3ffe8000, len 776, room 4
tail 4
chksum 0xe8
load 0x3ffe8308, len 540, room 4
tail 8
chksum 0xc0
csum 0xc0
2nd boot version : 1.4(b1)
SPI Speed : 40MHz
SPI Mode : QIO
SPI Flash Size & Map: 8Mbit(512KB+512KB)
jump to run user1 @ 1000
ŒÂÕ�MEM CHECK FAIL!!!
d{$�‚sú
Ai-Thinker Technology Co. Ltd.
invalid
What could be the reason for this statement?
Is it a regular operation statement without any further meaning for me?
I'm using the Arduino IDE with a baud rate of 115200 together with the board settings Generic ES8266 Module