ESP8266-01, Blue LED on Steady after successful test.
Posted: Tue Jan 09, 2018 10:21 amI'm testing my first ESP8266 WiFi module (with ESP-01 Adapter, with 3.3V, & level conversion)
My question is, after setting the baud rate last night, testing, and getting a good AT+GMR response, it now powers on to a steady Blue LED with no response to AT commands. Only an echo '>>>> AT' of the command sent.
This condition occurs when powered by outboard 5V power supply or Arduino. The adapter board has only 4 pins, TX, RX, Gnd, VCC.
I have not Flashed the ESP8266, and didn't want to.
What could cause this solid Blue suddenly?
Any guidance appreciated.
My question is, after setting the baud rate last night, testing, and getting a good AT+GMR response, it now powers on to a steady Blue LED with no response to AT commands. Only an echo '>>>> AT' of the command sent.
This condition occurs when powered by outboard 5V power supply or Arduino. The adapter board has only 4 pins, TX, RX, Gnd, VCC.
I have not Flashed the ESP8266, and didn't want to.
What could cause this solid Blue suddenly?
Any guidance appreciated.