ESP8266 Community Forum

Posted: **Sat Feb 09, 2019 6:59 am**

Hello,

today started working with ESP-07. I clould make the blink demo working.
Now I wanted to add an OLED display (Waveshare OLED 128x128 pixel (SSD1327))

https://www.waveshare.com/wiki/1.5inch_OLED_Module

In Arduino IDE I used the "Hello world" demo of following library:

https://www.arduinolibraries.info/libraries/u8g2

From this library I uncommented following constructor:

Code: Select allU8X8_SSD1327_MIDAS_128X128_4W_SW_SPI u8x8(/* clock=*/ 13, /* data=*/ 11, /* cs=*/ 10, /* dc=*/ 9, /* reset=*/ 8);

But now I have a problem, I do not really know how to wire the OLED display to my ESP-07.

The OLED display has follwing pins (Vcc and GND is obvious, so I did not mention them here):

In the documentation for ESP07 I found following SPI GPIO pins:

But I don't know what pin on OLED side to connect with what pin on ESP07 side.
Could someone explain it to me?

And what should I do with the RST pin of my OLED? There is no equivalent pin on ESP07 side.

I further have to set the correct pin numbers in the u8x8 constructor.

What ESP07 pin I have to enter in the constructor for:

The HelloWorld example has following setup-function:

Code: Select all

void setup(void)
{
  /* U8g2 Project: SSD1306 Test Board */
  //pinMode(10, OUTPUT);
  //pinMode(9, OUTPUT);
  //digitalWrite(10, 0);
  //digitalWrite(9, 0);      
  
  /* U8g2 Project: KS0108 Test Board */
  //pinMode(16, OUTPUT);
  //digitalWrite(16, 0);   
  
  u8x8.begin();
  u8x8.setPowerSave(0);
  
  
}

How I have to change it to work with my OLED?

Thanks a lot...

ESP8266 Community Forum

How to wire Waveshare OLED 128x128 pixel (SSD132) to ESP-07?

How to wire Waveshare OLED 128x128 pixel (SSD132) to ESP-07?