ESP8266 Community Forum

- Wed May 08, 2019 8:13 am #82192 Hi!
Can anybody tell me what does the "no tail" response mean?
It comes from an ESP8266 serially connected to an Arduino after I do the following:
AT+CIPSTART=4,"UDP", "192.168.4.2", 8080, 1112, 0
it answers 4 CONNECT OK
and then
AT+CIPSEND=4,5
to send a short string of 5 characters
And here appears the "no tail" response...
Google gives me no meaningful results about this.
Any help will be very much appreciated.
Thanx in advance

F.

- Thu May 09, 2019 4:41 pm #82234 boardsearch ....

use correct delimiter cr/lf

- Fri May 10, 2019 6:43 am #82245 Thanx for your answer. But... The datasheets say nothing of CR LF ending. It only says that if you send more bytes than expected the module will answer "busy". Even more, it says NO CR.
Still not clear what "no tail" means...

- Fri May 10, 2019 7:00 am #82246 but but but, since you are to reluctant (stupid?) to use board search as suggested:
viewtopic.php?f=160&t=19677&p=82135#p82071