Uart using with run_input = 0
Posted: Thu Dec 18, 2014 10:00 am
LS,
I am experimenting witht the uart functions using a slightly adapted version of your example.
What I notice :
1/ I still get the ">" prompt after each transmitted line. I would expect the lua interpreter to be silent with run_input = 0
2/ I get a ">>" prompt after sending the quit. Looks like the last input is still send to interpreter
Kind regards,
Herman
I am experimenting witht the uart functions using a slightly adapted version of your example.
Code: Select all
uart.setup( 0, 9600, 8, 0, 1, 0 )
uart.on("data",
function(data)
if data=="quit" then
uart.on("data")
uart.setup( 0, 9600, 8, 0, 1, 1 )
end
end, 0)
What I notice :
1/ I still get the ">" prompt after each transmitted line. I would expect the lua interpreter to be silent with run_input = 0
2/ I get a ">>" prompt after sending the quit. Looks like the last input is still send to interpreter
Kind regards,
Herman