ESP8266 Community Forum

Hi,

i've searched many hours for a solution without succes.
I tried to flash NodeMCU on my ESP12F.
I used the build from: http://nodemcu-build.com/
I have Linux and flashed via a FTDI232 with:
According to the output of esptool, the flashing worked.
After resetting and changing GPIO0 from GND to VCC there evrytime comes some gibberish followed by one of this three error messages:

• Code: Select alldon't use rtc mem data
• Code: Select allSelf adjust flash size.
• Code: Select allr�
 ets Jan  8 2013,rst cause:4, boot mode:(3,6)

wdt reset
load 0x40100000, len 26636, room 16
tail 12
chksum 0xa7
ho 0 tail 12 room 4
load 0x3ffe8000, len 2260, room 12
tail 8
chksum 0xe1
load 0x3ffe88d4, len 8, room 0
tail 8
chksum 0x3c
csum 0x3c

When the third error message comes, the ESP repeatedly reboots and outputs the same text again
As far as I know "rst cause:4" means watchdog reset

The ESP is connected to good power supply unit
CH_PD is pulled up
GPIO15 pulled down
VCC(FTDI) connected to VCC(ESP) and VCC of the PSU and the same with GND
RX(ESP) to TX(FTDI)
TX(ESP to RX(FTDI)
The FTDI is turned to 3.3V

I'm new to the ESP so maybe I did some fundamental errors.
I'm happy with every hint
Thanks

What speed are you using for serial communication? I had the best result with 9600 BAUD.

The error messages I posted was with 115200 Baud.
With 9600 baud I reieved only gibberish

The baud rate has nothing to do with this. Getting the right esp_init_data_default.bin does. Read Flashing the firmware for more info.