- Tue Jul 05, 2016 2:56 pm
#50255
I recently bought the Amica V2 (NodeMCU v1.0) and I am trying to program it with the Arduino IDE from my macbook. I've downloaded and installed Silicon Labs CP2102 USB to UART Bridge VCP Driver and it is listed in the system information (check the attachment) but it is not listed as a port in the Arduino IDE. Is there anything else I need to install?
Also, I haven't connected anything yet, I've only attached it to the breadboard (see other attachment). Thank you all in advance! Sorry I'm new to this.
Also, I haven't connected anything yet, I've only attached it to the breadboard (see other attachment). Thank you all in advance! Sorry I'm new to this.
You do not have the required permissions to view the files attached to this post.
