Led not blinking after successful flash.
Posted: Thu Oct 29, 2015 9:11 amHi, I am new to ESP8266 and I am having trouble getting the ESP8266 to work after successful flash.
After uploading to the ESP8266 via Arduino IDE, I presume "Uploading 205248 bytes from C:\Users\Ayden\AppData\Local\Temp\build5554887028620223454.tmp/ESP8266Blink.cpp.bin to flash at 0x00000000
........................................................................................................................................................................................................." has being flash into the ESP8266.
I am following this website http://www.arduinesp.com/blink and I remove the wires that is not needed that indicate on the website after the flash.
Any guidance please? The programming code is as for the website.
Thanks!
After uploading to the ESP8266 via Arduino IDE, I presume "Uploading 205248 bytes from C:\Users\Ayden\AppData\Local\Temp\build5554887028620223454.tmp/ESP8266Blink.cpp.bin to flash at 0x00000000
........................................................................................................................................................................................................." has being flash into the ESP8266.
I am following this website http://www.arduinesp.com/blink and I remove the wires that is not needed that indicate on the website after the flash.
Any guidance please? The programming code is as for the website.
Thanks!