From Blink to Web Server
Posted: Fri May 29, 2015 4:09 pm
ESP8266 Community Forum
Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/
From Blink to Web Server
Page 1 of 2
Posted: Fri May 29, 2015 4:09 pmRe: From Blink to Web Server
Posted: Sat May 30, 2015 3:06 amThanks Im interested in the switch setup on reset and to the LCD can you enlighten me with a diagram of how you have it set up . It does not seem to be in the fritzing diagram above
Re: From Blink to Web Server
Posted: Sat May 30, 2015 4:24 amI put a single pole - dual throw switch to select whether the TX line (blue wire) of the ESP is connected to the RX of the FTDI (Serial interface) or to the RX of the 9600 baud serial LCD Display.
During sketch upload, the switch connects ESP to the FTDI. During normal operation the switch connects ESP to the LCD.
That's it, very boring, but does the job.
During sketch upload, the switch connects ESP to the FTDI. During normal operation the switch connects ESP to the LCD.
That's it, very boring, but does the job.
Re: From Blink to Web Server
Posted: Sat May 30, 2015 2:17 pmAmazig video !!
I guess my next task is to learn a little HTML, always good to study new things.
I created a webserver too based on your video. But I can only reach it from the same wifi network. How can I make a webserwer which is globally available?
I guess my next task is to learn a little HTML, always good to study new things.
I created a webserver too based on your video. But I can only reach it from the same wifi network. How can I make a webserwer which is globally available?