AP doesn´t detect client connected
Posted: Tue Oct 11, 2016 9:48 amGreeting, I´m new with the use of the esp8266 been working with for about a week now, i´m working with a project where two esp(for now, later more modules will be aded) need to share data, successfully connected one working as client to the AP but this last one never seems to detect when the client is connected, it probably is a little detail in the code but i hope someone can guide me here. I'll leave the code for the two esp modules i´m using.
This is the one working as a station altough both esp are configured as AP and STA because i´ll need them to change roles later. This esp connects with succes and it prints a confirmation in the serial monitor.
And this is the one working as an AP, it never seem to detect the client when it connects and keeps printing in the monitor "no client"
This is the one working as a station altough both esp are configured as AP and STA because i´ll need them to change roles later. This esp connects with succes and it prints a confirmation in the serial monitor.
Code: Select all
//ENTREGA MENSAJE(07)
#include <ESP8266WiFi.h>
char bandera;
WiFiServer Nserver(9001);
WiFiClient Nclient;
void setup() {
Serial.begin(115200);
WiFi.disconnect();
WiFi.mode(WIFI_AP_STA); //access point y estación
WiFi.softAP("modulo_01"); //nombre del AP
Nserver.begin();
WiFi.begin("modulo_07","",9001);
}
void loop() {
while(WiFi.status() != WL_CONNECTED){ //see if it connected
Serial.println("no connected");
delay(1000);
}
while(WiFi.status() == WL_CONNECTED){
Serial.println("connected");
Nclient.println('1');
Serial.println("bandera send :1");
delay(1000);
}
}And this is the one working as an AP, it never seem to detect the client when it connects and keeps printing in the monitor "no client"
Code: Select all
//RECIBE MENSAJE(01)
#include <ESP8266WiFi.h>
char bandera;
WiFiServer Nserver(9001);
WiFiClient Nclient;
void setup() {
Serial.begin(115200);
WiFi.disconnect();
WiFi.mode(WIFI_AP_STA); //access point y estación
WiFi.softAP("modulo_07"); //nombre del AP
Nserver.begin();
}
void loop() {
if(Nclient){
WiFiClient Nclient = Nserver.available();
Serial.println("client connected");
if(Nclient.available()){
bandera = Nclient.read();
Serial.println(bandera);
Serial.println("bandera received : 1");
}
}
else{
Serial.println("no client");
delay(500);
}
}