- Sat May 20, 2017 5:43 am
#66117
Hi there,
I have a project where I'm looking at receiving motor commands in an hoverboard. The hoverboard main board send commands to motor control board using UART communication using a strange configuration - at least not usual. It uses a speed of 23600 bauds and send data on a 9 bits, 1 start and 1 stop.
I ideally would need 2 port to receive information for the two motors.
Do you think these can be achieved on ESP8266?
I haven't see such configuration in ESP8266 datasheet for the hardware UART.
Thanks
I have a project where I'm looking at receiving motor commands in an hoverboard. The hoverboard main board send commands to motor control board using UART communication using a strange configuration - at least not usual. It uses a speed of 23600 bauds and send data on a 9 bits, 1 start and 1 stop.
I ideally would need 2 port to receive information for the two motors.
Do you think these can be achieved on ESP8266?
I haven't see such configuration in ESP8266 datasheet for the hardware UART.
Thanks
