Are old esp8266 01 still useable
Posted: Sun Jan 27, 2019 6:36 am
Hi guys,
I have about a dozen old esp8266 01 boards that I think some time ago I flashed with Nodemcu, when I connect them and open Arduino IDE they do not seem to program, however in the serial monitor I tried changing the baud rate, the only one that worked was 74880, when i press reset on the device i get:
ets Jan 8 2013,rst cause:1, boot mode:(3,6)
load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
vffffffff
~ld
Is there a way of flashing new firmware with a useable baud rate or are they now just Toast ?
Thanks in advance
Stuart
I have about a dozen old esp8266 01 boards that I think some time ago I flashed with Nodemcu, when I connect them and open Arduino IDE they do not seem to program, however in the serial monitor I tried changing the baud rate, the only one that worked was 74880, when i press reset on the device i get:
ets Jan 8 2013,rst cause:1, boot mode:(3,6)
load 0x4010f000, len 1384, room 16
tail 8
chksum 0x2d
csum 0x2d
vffffffff
~ld
Is there a way of flashing new firmware with a useable baud rate or are they now just Toast ?
Thanks in advance
Stuart