ESP12F doesnt work after I recycle the power.
Posted: Wed Aug 18, 2021 8:59 am
Hi,
I have setup auto programming of ESP12F module with CH340G. The program runs well once i upload program via arduino. As long as board is powered up it runs. But once i recycle the program doesnt run!!
How to solve this issue?
However I have noticed that once i connect the reset to ground, the program runs normally. Everytime there is a recycle in power i do not prefer to do hard reset.
https://drive.google.com/file/d/1kCW1K1uQJ0-ODv3Mv5xdFqboc_Gik1rQ/view?usp=sharing
I have setup auto programming of ESP12F module with CH340G. The program runs well once i upload program via arduino. As long as board is powered up it runs. But once i recycle the program doesnt run!!
How to solve this issue?
However I have noticed that once i connect the reset to ground, the program runs normally. Everytime there is a recycle in power i do not prefer to do hard reset.
https://drive.google.com/file/d/1kCW1K1uQJ0-ODv3Mv5xdFqboc_Gik1rQ/view?usp=sharing