ESP8266 Community Forum

Posted: **Sun Jan 31, 2016 6:25 pm**

So this may not be the correct place to ask this, but I can't flash my ESP8266 (ESP-01). I have 3.3v and ground connected, Rx to Tx and Tx to Rx on my usb to serial adaptor. I also have GPIO0 connected to ground too.

I am using an external power supply but the usb adaptor and power adaptor share a common ground.

I'm using a mac and esp tools to flash it, and it has worked before.
The command I am using is:

Code: Select allsudo ./esptool.py --port /dev/tty.wchusbserial1410 write_flash 0x00000 AT22SDK10020150320boot12.bin

But the response is:

Code: Select allA fatal error occurred: Failed to connect to ESP8266

This make me think something is wrong with receiving data from the ESP because when attempting to connect, the ESPs blue LED flashes.

My usb to serial adaptor works fine though as i've tested it with my arduino.

Posted: **Wed Feb 17, 2016 6:48 am**

hi,

For me also the same error getting last 1 week trying to solve this.
somebody have any suggestion?

Posted: **Thu Feb 18, 2016 8:25 am**

Is CH_PD connected?

Posted: **Thu Feb 18, 2016 8:56 am**

You should use the following parameters:< -fm dio -fs 32m -ff 40m > at the end on the command line.

ESP8266 Community Forum

Not able to flash esp-01

Not able to flash esp-01

Re: Not able to flash esp-01

Re: Not able to flash esp-01

Re: Not able to flash esp-01