ESP8266 01 in reset loop after programming it using Arduino
Posted: Tue Feb 23, 2016 6:08 amHi All,
I am trying to upload a sketch on my ESP 01 module, I am able to upload my sketches to the module but my when I am trying to use Serial.begin command at 115200 baud rate (or any other ) I start getting this message continuously -
wdt reset
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
I have tried to upload default Blink program for ESP8266, it works fine after upload and blue led light starts blinking. But as I add Serial command to my sketch it blinking stops and i can see reset messages on my screen at 115200 baud rate.
My module was responding to AT commands before I uploaded, and now that i have uploaded new sketch it has stopped resopding to AT commands too ( this is i think usual behavious as I have changed its firmaware )
I am trying to figure this with no success, my circuit diagram is soldered .
Please help me on this I am a bit hopeless right now , if anyone has faced this issue.
Thanks in advance!
I am trying to upload a sketch on my ESP 01 module, I am able to upload my sketches to the module but my when I am trying to use Serial.begin command at 115200 baud rate (or any other ) I start getting this message continuously -
wdt reset
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
I have tried to upload default Blink program for ESP8266, it works fine after upload and blue led light starts blinking. But as I add Serial command to my sketch it blinking stops and i can see reset messages on my screen at 115200 baud rate.
My module was responding to AT commands before I uploaded, and now that i have uploaded new sketch it has stopped resopding to AT commands too ( this is i think usual behavious as I have changed its firmaware )
I am trying to figure this with no success, my circuit diagram is soldered .
Please help me on this I am a bit hopeless right now , if anyone has faced this issue.
Thanks in advance!