ESP8266 Community Forum

following previous istruction , in basic V1.94 a simple basic program (named /default.bas) is running after 60 second on boot (if no access from edit/setting page is required)

with firmaware V 2 or 3 this don't happens : the program run ONLY on command "run" from the edit mask (without edit or open .. because it's resident and visible on the edit mask )

There is some file to set to force this action ? , There is other way to obtain this function ?

I'm waiting on your aswer (otherwise I'm locked ) thank you

errr dunno if 1.94 had that implemented yet but you can use the flasher utility to clear flash memory I wrote how to do this in my espbasic guide.

Follow the link in my signature I think it at the bottom of page 1 in the troubleshooting section.

what you can try is saving a blank file name possibly...

I guess the question is a bit hard to understand.

But as far as running in the settings page on v2 there is a checkbox to run the default program at boot.

For running on version 1.x I believe it was saving the file as a blank file name

So you can save a blank file and run this should allow you access again.

If all else fails erase the flash follow the instructions you may have to do it a couple of times do not give up easy.