ESP8266 Community Forum

Currently to run the default.bas, I am typing "192.168.4.1/run".

İs it possible just typing "192.168.4.1" and ENTER then get the default.bas run? I think this way will be more formal.

Like the other web servers, when you type IP address only, they look for an index.xxx file, find it and run it.

If you go to the settings page you can set the default index page not to display the main menue up at the top.

You can also turn on the auto run. This will run the default program 30 seconds after boot up.

You probably want to create some kind of gui for your program and make it so that you dont have to run it fresh each time it is used.

If a program is already runing just visition the ip adress of the device will show the gui for that program.