Sleeping mode
Posted: Sun Nov 15, 2015 2:21 pmIs there any command to put the esp8266 in sleeping mode when all activities have been done?
ESP8266 Community Forum
Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/
Sleeping mode
Page 1 of 3
Posted: Sun Nov 15, 2015 2:21 pmRe: Sleeping mode
Posted: Sun Nov 15, 2015 10:42 pmBeen thinking about doing some thing like this. As i understand it right now a sleep is possible but there are some pit falls. Will have to investigate and see if its some thing that could be done with the basic interpreter.
Re: Sleeping mode
Posted: Mon Nov 16, 2015 12:03 amadded sleep command to v1.40 available for download now.
syntax:
example:
Will put device to sleep for a number of seconds.
Things to note. Sleep mode will cause a full reboot of the device. It will start the device and run the default program from the beginning. It takes 30 seconds before the device starts the default program after reboot.
GPIO16 needs to be tied to RST to wake from Sleep.
Will have to look in to saving the full state of the basic program prior to sleep. That way sleep mode could be like a delay.
syntax:
Code: Select all
sleep {value or var in seconds}example:
Code: Select all
sleep 600Will put device to sleep for a number of seconds.
Things to note. Sleep mode will cause a full reboot of the device. It will start the device and run the default program from the beginning. It takes 30 seconds before the device starts the default program after reboot.
GPIO16 needs to be tied to RST to wake from Sleep.
Will have to look in to saving the full state of the basic program prior to sleep. That way sleep mode could be like a delay.
Re: Sleeping mode
Posted: Thu Nov 19, 2015 2:37 amI'm using Esp01. I tried the new sleep command but the esp8266 do not wake up after the time exipired. The only way to resume esp8266 working is to physically reset.