Page 1 of 2
Password for AP mode?
Posted:
Sun Mar 27, 2016 3:38 pmby cwilt
I did a format and flash of a nodemcu. When I scan for the AP it is displayed as ESP1 but secured. I tried to wipe the flash using other tools yet it still requests a password.
Anyone else?
Re: Password for AP mode?
Posted:
Sun Mar 27, 2016 5:22 pmby cwilt
I flashed a different device and did not have this issue. It is most likely that the format and flash is not clearing everything. Updates will be posted here as I figure it out. Most likely I will flash the original AT firmware. That has worked for me in the past to revive nodes before.
Re: Password for AP mode?
Posted:
Sun Mar 27, 2016 6:36 pmby Mmiscool
If you use the format button in the flasher it will flash a formware that should format the device. You have to wait a minuet or so after flashing that to flash ofher firmware back on it.
Re: Password for AP mode?
Posted:
Sun Mar 27, 2016 8:24 pmby cwilt
Mmiscool wrote:If you use the format button in the flasher it will flash a formware that should format the device. You have to wait a minuet or so after flashing that to flash ofher firmware back on it.
I waited 3 minutes.