- Sun Sep 14, 2014 1:11 pm
#542
Thanks for sharing!
One question: You find you don't have to do a reset after a CWMODE? I've always had to, and I believe the data sheet says it's required.
One question: You find you don't have to do a reset after a CWMODE? I've always had to, and I believe the data sheet says it's required.
- Mon Sep 15, 2014 12:41 am
#561
its just that I only have 3.3v ADP121 in my bin when my ESP module came, so i test it with, and it run without issue.
another esp module i have, is running with arduino pro micro. pro micro is using LP2985 for 3.3v, also rated at 150mA.
Squonk wrote:I was worried because of this video:I wouldnt suggest also a 3.3V with less than 300mA.
https://www.youtube.com/watch?v=1z33HvusM-A
its just that I only have 3.3v ADP121 in my bin when my ESP module came, so i test it with, and it run without issue.
another esp module i have, is running with arduino pro micro. pro micro is using LP2985 for 3.3v, also rated at 150mA.
- Mon Sep 15, 2014 12:52 am
#563
i just tested mine with CWMODE, all 3 modules i have dont need RST after issuing CWMODE.
and my host controller doesnt issue the command after every power up.
JDub wrote:Thanks for sharing!
One question: You find you don't have to do a reset after a CWMODE? I've always had to, and I believe the data sheet says it's required.
i just tested mine with CWMODE, all 3 modules i have dont need RST after issuing CWMODE.
and my host controller doesnt issue the command after every power up.
