ESP8266 Community Forum

- Thu Dec 18, 2014 4:38 am #5047 Hello Becdac,
great software.

One could point you are trying to change in yourself, send the ESP to the client comes first one
character and then delayed the rest. This confuses some clients.
You can not leave this deficiency?

Allex

- Thu Dec 18, 2014 6:41 am #5052

This is a nice idea. I'd have to learn more about the protocol. For the ESP boards with more GPIOs available (i.e. not the -01) the flow control lines could be implemented fully. Even with the ESP-01, the free GPIO could be used as RTS or CTS to initiate an Arduino reset.

I've seen that the Ethersex project has implemented Yport on AVR micros.
http://www.ethersex.de/index.php/Main_Page
https://github.com/ethersex/ethersex/tr ... cols/yport

Ethersex is a great project, that supports all sorts of interfaces and protocols, and even has it's own scripting language.
I'd love to see that ported to the ESP8266.

- Thu Dec 18, 2014 10:08 am #5076

How to initialize bridge between 2 arduinos? With 2 ESPs off course.

Disclaimer, I've not tried this, but it seems like one would have to initiate the connection. This firmware, as it stands, only accepts incoming TCP connections. Making outgoing TCP connections is not supported, at this time.

So, I have to setup first ESP 1 with 922 firmware as a AP, and establish connection from ESP 2 with Your firmware as a client?

Which command will send a data from ESP1 to ESP2 port using arduino?

- Thu Dec 18, 2014 2:46 pm #5099 Per requests on github and here, I have added two new commands to set the baud rate and the TCP port. These need more testing, but it should be a place to start. Updated the first post.