- Tue Jun 14, 2016 11:51 am
#49188
Hi everyone,
I'm beginning to research about esp8266 with esp-12 kit
I finished the load firmware step, all was fine but there are some problem when I test with AT command. I use ESP board manager on arduino IDE to send "AT" via serial, but the esp8266 module don't response anything. And when I test with ESPlorer, it's always waiting on "Communication with MCU ...... " line. I removed the connection between GPIO 0 and GND.
GPIO 2 and 15 is float.
What do I wrong?
I'm beginning to research about esp8266 with esp-12 kit
I finished the load firmware step, all was fine but there are some problem when I test with AT command. I use ESP board manager on arduino IDE to send "AT" via serial, but the esp8266 module don't response anything. And when I test with ESPlorer, it's always waiting on "Communication with MCU ...... " line. I removed the connection between GPIO 0 and GND.
GPIO 2 and 15 is float.
What do I wrong?
