- Fri Jul 15, 2016 1:05 pm
#50813
I'm finding that from time to time, my Lua files and the NodeMCU firmware disappear from my ESP8266-01.
I reflash NodeMCU and reload Lua scripts then I'm good to go - for a while.
This has happened on several ESPs.
GPIO0 and GPIO2 are hard wired to 3V3 via 1K resistors.
Supply voltage measured at 3.30V
Lua script makes occasional use of serial in and out (Rx and Tx) pins.
Any idea what goes on?
Could this have anything to do with the code in my Lua scripts?
I reflash NodeMCU and reload Lua scripts then I'm good to go - for a while.
This has happened on several ESPs.
GPIO0 and GPIO2 are hard wired to 3V3 via 1K resistors.
Supply voltage measured at 3.30V
Lua script makes occasional use of serial in and out (Rx and Tx) pins.
Any idea what goes on?
Could this have anything to do with the code in my Lua scripts?
