ESP8266 Community Forum

- Thu Aug 04, 2016 8:22 am #52105 Hi,

My ESP8266 module seem to be running in 11g mode. However i'd like to run a pure 11n network. From the specs the Module should support 802.11n. Is there an AT-command with which i could switch it to 802.11n-only?

- Sun Aug 07, 2016 7:40 am #52395 If not by AT-commands, is there another way to enable N-mode?
It doesn't use N-Mode even if the signal is excellent.

- Fri Aug 12, 2016 3:59 am #52767 Apparently if i set the AP to WPA2-only, it forces the devices to do N-Mode.