- Sun Aug 21, 2016 10:21 am
#53494
Have spent an entire week trying to see an AP with the AT+CWLAP command. My board shows up in my internet connections, and I can see it with my Android, but the board never finds any APs. I finally dug an old wireless router out of the basement and I can see that one! Using an ESP8266-12 with an SMCD3GNV modem/router and running unmodified Ai-Thinker software (got 10 of these modules from Banggood). It joins to the Netgear N150 router just fine - but it's kind of useless if I can't get it connected to my home network. I looked at the router configuration to see if it had an 'exclude tiny Chinese Chips' setting, but to no avail. My system is set to use 10.0.0.xx ip addresses - can't remember why, but it's been that way for 5 years. Does anybody have any suggestions? I'm all out of them. Thanks.
- Tue Aug 23, 2016 7:44 am
#53658
I loaded the 'HelloServer' sketch from the Arduino examples folder, and can now access my network. Still don't know why it didn't see both APs though in Esplorer.... Stay tuned for my next problem I'm sure there will be many.
