- Wed Nov 02, 2016 6:07 pm
#57567
hi, i am trying to connect my arduino uno, which is used as usb to uart for my computer, with esp8266 esp-13 and esp-12. but i can not receive any answer from esp-13 and esp-12. i have given 3.3 volts (1amp) to the vcc pin and enable pin. than i connected tx rx gnd to my arduino uno board. do someone help me about that?
It takes about 20-25 seconds for home assistant c[…]
I tried to upgrade tof my sonoff basic R2 with the[…]
a problem Perhaps you want to define "Probl[…]
Rebooting your router will not give you a faster I[…]
There are no other notifications from esptool.py i[…]
Using the Arduino IDE, you'll learn how to set up […]
In this project, you will post to Twitter using an[…]
In this project, we will build a water level contr[…]
I guess I'm late, but I had the same problem and f[…]
Last night I received my first D1 Minis for a lear[…]
Although I am aware that this is an old post, I fe[…]