- Wed Dec 14, 2016 5:16 pm
#59505
I have an Adafruit Hazzah board. GPIO0 is connected to an LED that I want to blink. My problem is that I am occasionally getting a watchdog reboot.
The board comes back up and sometimes it wants to boot to UART mode.
My question is this....am I programmatically putting the board into UART mode or does the chip reset on watchdog timeout and then set the pins back to inputs before reading for boot settings?
Thanks in advance
The board comes back up and sometimes it wants to boot to UART mode.
My question is this....am I programmatically putting the board into UART mode or does the chip reset on watchdog timeout and then set the pins back to inputs before reading for boot settings?
Thanks in advance
