ESP8266 Community Forum

Posted: **Thu Feb 19, 2015 6:14 am**

Hi everyone. My ESP doesn't respond to any AT commands. But if I send reset signal on RST pin it answer me:

[Vendor:www.ai-thinker.com Version:0.9.2.4]

ready

So I decided to reflash it but XTCOM can not connect to it. After pushing "Connect" button it says that connection is failed.

Posted: **Fri Feb 20, 2015 3:47 am**

I had similar problems, i had to disconnect and reconnect to my COM device, then the AT command did work.

On my arduino, there was no such issue.

Also be sure to send your commands with a new line (CR + LF)

ESP8266 Community Forum

Can't make ESP work

Can't make ESP work

Re: Can't make ESP work