Getting signal strength command
Posted: Wed Sep 24, 2014 3:59 pmanyone knows, if there is a command to get the signal strength?
This would be helpful for implementing a mesh network...
This would be helpful for implementing a mesh network...
ESP8266 Community Forum
Open Community Forum for ESP8266, Come share Arduino and IoT (Internet of Things)
https://www.esp8266.com/
Getting signal strength command
Page 1 of 4
Posted: Wed Sep 24, 2014 3:59 pmRe: Getting signal strength command
Posted: Wed Sep 24, 2014 4:12 pmDoes it support Ad-hoc mode? Without that it is going to be hard to make a mesh.
Re: Getting signal strength command
Posted: Wed Sep 24, 2014 5:16 pm2 good points, keep us informed I am sure lots want to here about a mesh for ESP8266EX
Richard.
Richard.
Re: Getting signal strength command
Posted: Wed Sep 24, 2014 5:56 pmwhy is ad-hoc necessary?
Each node can act as AP and station.
So, if a node cannot reach the master, it could connect to the nearest (hops) station.
Each node can act as AP and station.
So, if a node cannot reach the master, it could connect to the nearest (hops) station.