ESP8266 Community Forum

- Wed Oct 23, 2019 2:57 pm #84292 Hi

Trying to get in contact with my ESP8266MOD, using an FT232RL hooked up to a PC.

The closest I get is when I use baud rate 76800, then I get this after a reset, see below..
It does not recognize any AT commands, they don't seem to get through.

Any suggestions?

Thanks!

- Fri Oct 25, 2019 12:05 pm #84305 Thanks, but my issue is already solved by info from other forums, long before my post was even approved in this one...

- Sat Oct 26, 2019 6:48 am #84311 Hi

It would help others with such issues if you could at least post a link to the solution.
It would also help if you appended 'Solved' to the subject title.

Thanks

- Thu Oct 31, 2019 4:07 pm #84384 My ESP8266 development board with USB UART, Not responding to AT commands ...tried N no of ways,but no use.. changed many AT firmware...still no use..someone plz help...this site is confusing, to raise a new topic, so posted here...plz help