ESP8266 Community Forum

- Tue May 05, 2020 5:52 am #86925 hi everyone
I have a PCB which has an ESP8266-07 chip on it and the necessarily pins for programming the chips is out too.
I need a standalone programmer that can burn my .bin file into the chip. do you have any suggestions?
by the way, my board can handle 5V too so the chip won't get damaged.

- Tue May 05, 2020 2:46 pm #86933

I need a standalone programmer that can burn my .bin file into the chip. do you have any suggestions?

You need a USB to serial adapter.

Have a look here :- http://ediy.com.my/blog/item/133-upload-sketch-to-the-esp8266-esp-07-esp-12-using-arduino-ide

- Tue May 05, 2020 11:33 pm #86939 thanks for your reply dear but with the usb2serial module, I need to use PC. By standalone programmer I meant:
a programmer which get the ".bin" file for once and then, flashes as many boards as I want without using a PC.

- Wed May 06, 2020 5:13 pm #86945

flashes as many boards as I want without using a PC

The esp8266 has a serial programming interface.

As far as I am aware you cannot 'gang bang' them like EPROMs.

If I am wrong the forum members will correct me.