- Wed Dec 23, 2020 4:58 am
#89923
Hello
I change Baudrate of esp07 module trough AT-command to 1200 with following command :
but it don't work any more.
I did change wiring to boot on Bootloader and did change pc-sofware's baudrate to 74880 to see bootloader log but unreadable messages (but formated) are printed when i restart the module. Like this :
GÔZˆQP@XdY…w ÌQ+kCP@æo ÔWZ5•V‰DD
or
GÄZˆQP@XdY…g ÌQ+kSPPöo ÔWZ5•F‰DT
or
GÄZˆQ@@XdY…g ÌQ+kCP@öo ÔWJ5•V™DD
and so ...
I skip above story and try to flash with a new firmware but i can't.
What can i do to recover my module?
I change Baudrate of esp07 module trough AT-command to 1200 with following command :
AT+UART_DEF=1200,8,1,0,0
but it don't work any more.
I did change wiring to boot on Bootloader and did change pc-sofware's baudrate to 74880 to see bootloader log but unreadable messages (but formated) are printed when i restart the module. Like this :
GÔZˆQP@XdY…w ÌQ+kCP@æo ÔWZ5•V‰DD
or
GÄZˆQP@XdY…g ÌQ+kSPPöo ÔWZ5•F‰DT
or
GÄZˆQ@@XdY…g ÌQ+kCP@öo ÔWJ5•V™DD
and so ...
I skip above story and try to flash with a new firmware but i can't.
What can i do to recover my module?
