ESP8266 Community Forum

Posted: **Tue Apr 28, 2015 3:36 am**

Hi,
I have just discovered the beauty with this module and was about to try out the NodeMCU firmware. The flashing went great (using the official flasher) and startet using the ESplorer to send some code over to it. It worked and I connected to my wifi and got an address. But suddenly the connection died and I was unable (still) to talk to it via FTDI but connects to my network.

I am unable to either flash the module or talk to it. Anyone got any ideas? Thanks

Posted: **Tue Apr 28, 2015 9:25 am**

Make sure you are using an adequate (3.3v) power supply. Also ensure that CH_PD is still connected to VCC.

Posted: **Tue Apr 28, 2015 11:21 am**

I am using CP2102 to connect to it. The CH_PD have power from VCC.
Do you recommend using an external psu? for example the ywrobot ?

Posted: **Tue Apr 28, 2015 2:21 pm**

sweg wrote:I am using CP2102 to connect to it. The CH_PD have power from VCC.
Do you recommend using an external psu? for example the ywrobot ?

CP2102 does not provide enough power. Do a search on this board and you will find great advice. good luck..

ESP8266 Community Forum

Is my ESP8266 dead?

Is my ESP8266 dead?

Re: Is my ESP8266 dead?

Re: Is my ESP8266 dead?

Re: Is my ESP8266 dead?