ESP-01 with SDK 1.3.0?
Posted: Sun Aug 16, 2015 3:11 pmI have an ESP-01 that I'd like to upgrade the firmware on to the latest. I wanted to find out is anyone has gone through this and can confirm the .bin files in the SDK (without rebuilding) will work on the ESP-01 with 512KB flash?
The documentation says use the following for 512KB:
eagle.flash.bin 0x00000
eagle.irom0test.bin 0x40000
blank.bin 0x7E000
esp_init_data_default.bin 0x7C000
master_device_key.bin 0x3E000 (If you want cloud service) ...... not sure if this is required if you don't want cloud service.
I wanted to avoid going through the build effort, but from what I've been reading I'm somewhat concerned that the SDK build is run assuming 1024KB flash.
The documentation says use the following for 512KB:
eagle.flash.bin 0x00000
eagle.irom0test.bin 0x40000
blank.bin 0x7E000
esp_init_data_default.bin 0x7C000
master_device_key.bin 0x3E000 (If you want cloud service) ...... not sure if this is required if you don't want cloud service.
I wanted to avoid going through the build effort, but from what I've been reading I'm somewhat concerned that the SDK build is run assuming 1024KB flash.