- Sun Oct 11, 2015 4:49 pm
#31123
Hi,
My ESP is set up using the tutorials at:
http://www.esp8266.nu/index.php/Main_Page#Tutorials
when using:
http://ESP_IP/control?cmd=GPIO,2,1
the attached LED on the GPIO comes up (or off:...,0)
FINE.
Unfortunatly, all the installation proceures at
http://www.esp8266.nu/index.php/Tutoria ... icz_Switch
did not yet lead me to a correctly connected Domoticz and esp.
The switch will not be switchable from there and it will also not deiplay ist state.
It seems they are not at all conected ....
how / where could I debug?
BrP
My ESP is set up using the tutorials at:
http://www.esp8266.nu/index.php/Main_Page#Tutorials
when using:
http://ESP_IP/control?cmd=GPIO,2,1
the attached LED on the GPIO comes up (or off:...,0)
FINE.
Unfortunatly, all the installation proceures at
http://www.esp8266.nu/index.php/Tutoria ... icz_Switch
did not yet lead me to a correctly connected Domoticz and esp.
The switch will not be switchable from there and it will also not deiplay ist state.
It seems they are not at all conected ....
how / where could I debug?
BrP
